Naniwa Sink Bridge Review: A Clean, Stable Sharpening Station Anywhere
No sink at your sharpening spot? A Naniwa sink bridge over a food-service tray turns any table into a level, contained sharpening station.
By Burrfection EditorialOctober 20, 2016Updated November 21, 20263 min read
This article contains affiliate links: I may earn a commission if you buy through them, at no extra cost to you. How this works

The short version
- The Naniwa sink bridge is built tough. Stainless steel that won't flex, with rubberized ends that keep it planted.
- You don't need a sink. Clamp it inside a 6-inch-deep food-service tray and you have a portable station that holds your water and your stones.
- It's not essential, but it makes sharpening neater and more pleasant. It gives you a level, neutral base that anyone can learn on.
Why I use a sink bridge
I've used a sink bridge for a long time, because it keeps all the water in one contained area, with the bucket of water and your stones right there waiting for you (0:00). Let me be clear: this isn't a must-have. I sharpen a lot, and for me an accessible, decent-quality setup matters. If you're sharpening a few knives a month on one stone, a towel on the counter works fine.
Build quality
The Naniwa sink bridge is really high-quality stuff: you can tell it's stainless steel, and it's built so tough you can't bend it (0:45). The rubberized ends make it sturdy and stable on whatever it's sitting on. As the name suggests, it's made to sit across a sink. My old house has an oddly shaped sink it won't fit, so I use mine indoors in the studio instead.
On top of the bridge I put a rubber whetstone base (1:27). It's about a $20 part, and it does two jobs: it gives my knuckles more clearance, and it protects both the stone and the bridge. Stones are ceramic or glass, and I don't want my tools getting scratched up all the time. If you're going to invest $300 to $400 in stones and knives, it's worth spending a bit more on a proper setup to hold them.
Setting it up over a tray
Instead of a sink, I use a full-size food-service tray, the kind restaurants use, that's 6 inches deep (2:09). There's a 4-inch version too, which is nice, but I sharpen a lot and the extra water helps. They're cheap, around $24 to $25, and they make it easy to carry water: fill it at the kitchen sink or the hose, then walk it to your bedroom, studio or wherever you want your sharpening station.
To mount the bridge, push its ends out until it's fully extended against the inside of the tray, then tighten the knob (3:14). Set the stone base on top, put your whetstone in it, and tighten it down. Instead of relying on a little stop to keep the stone from sliding, you can also turn the tray so the stone is locked in solidly.
A level, neutral base
What you end up with is a sturdy, level base, and a flat, neutral surface is something anyone can learn on (3:56). When I put mine together, the whole setup cost about as much as a decent whetstone. It won't sharpen your knife for you, but it makes sharpening more pleasant, easier and much neater, with everything in one package.
Bottom line
A sink bridge is a luxury, not a requirement, but if you sharpen often it keeps water, stones and mess in one place and gives you a stable platform to learn on. The Naniwa sink bridge is the one I use. If you're still building your setup, my essential knife sharpening kit guide and the sharpening kits at the Burrfection Store are good places to start.
First access
Private drops, new knives and sales
Get them from Burrfection and our retail partners before anyone else. No spam; unsubscribe anytime.
Emails from Burrfection Inc. See privacy.


